camsnap

Capture frames or clips from RTSP/ONVIF cameras.

作者: admin | 来源: ClawHub

源自

ClawHub

版本

V 1.0.0

安全检测

已通过

58
下载量

0
收藏

概述

安装方式

版本历史

camsnap

# camsnap Use `camsnap` to grab snapshots, clips, or motion events from configured cameras. Setup - Config file: `~/.config/camsnap/config.yaml` - Add camera: `camsnap add --name kitchen --host 192.168.0.10 --user user --pass pass` Common commands - Discover: `camsnap discover --info` - Snapshot: `camsnap snap kitchen --out shot.jpg` - Clip: `camsnap clip kitchen --dur 5s --out clip.mp4` - Motion watch: `camsnap watch kitchen --threshold 0.2 --action '...'` - Doctor: `camsnap doctor --probe` Notes - Requires `ffmpeg` on PATH. - Prefer a short test capture before longer clips.

通过对话安装

该技能支持在以下平台通过对话安装：

OpenClaw WorkBuddy QClaw Kimi Claude

方式一：安装 SkillHub 和技能

帮我安装 SkillHub 和 xxx-1775987581 技能

方式二：设置 SkillHub 为优先技能安装源

设置 SkillHub 为我的优先技能安装源，然后帮我安装 xxx-1775987581 技能

通过命令行安装

skillhub install xxx-1775987581

下载 Zip 包

⬇ 下载 camsnap v1.0.0

文件大小: 1.05 KB | 发布时间: 2026-4-13 12:40

v1.0.0 最新 2026-4-13 12:40

Initial release of camsnap.

- Capture snapshots or video clips from RTSP/ONVIF cameras via command line.
- Supports camera discovery, motion event watching, and diagnostic tools.
- Requires a YAML config file for camera setup.
- Installable via Homebrew.
- Depends on ffmpeg for media handling.